What to do when outdoor ozone becomes your indoor problem
The EPA treats an eight-hour average above 70 parts per billion as unhealthy, and research suggests lower levels can still affect the lungs. How ozone gets in, and what takes it out.
Is ambient ozone an IAQ problem in your workplace or home? The US EPA has said an eight-hour average exposure greater than 70 parts per billion is considered unhealthy. But 70 PPB may not be safe enough. There is a growing body of research suggesting that much lower levels of ozone can diminish lung function, especially for children and people with other risk factors, such as advanced age, pregnancy, and respiratory conditions.
Ozone is a reactive gas with an oxidizing, corrosive effect on living cells and tissues. Both short-term and long-term exposure to ozone are harmful to health.
Infiltration happens easily when doors or windows are left open, allowing ozone to enter a space, or when outside air is used for ventilation. Even with windows closed, indoor ozone can reach 25 to 50% percent of the outdoor ozone level. HVAC systems do not inherently reduce it.
HVAC systems also don’t eliminate ozone formed indoors due to a range of products used including ozone-generators, some water purification systems, photocopiers, and laser printers. Additionally, when ozone combines with other VOCS and household chemicals, toxic formaldehyde gas can be produced.
Short term exposure
- Shortness of breath, wheezing, and coughing
- Increased risk of asthma attacks and respiratory infections
- Increased susceptibility to pulmonary inflammation and medical emergencies
Long-term ozone exposure
- Respiratory illnesses
- Metabolic disorders
- Nervous system issues
- Reduced fertility
- Poor birth outcomes
- Cardiovascular disease
- Cancer
Ozone can be good or bad, depending on the altitude.
High above us, stratospheric ozone forms the ozone layer, blocking the sun’s harmful ultraviolet rays. That’s the good ozone. And the good news is that the hole in the ozone layer is diminishing, thanks to a full ban of CFCs and other ozone destroying chemicals since 2010.
Tropospheric ozone, also known as ground-level ozone, is the bad news. Bad for your health, bad for animals and plants, and bad for the environment. Even though ozone levels in the US on average are below the safety level established by the EPA of 70 PPB (parts per billion), that rate is frequently exceeded in problem areas. In the US, most of the cities with the highest ozone levels are in the southwest and west, as the sunny, dry climate is favorable to ozone formation. But ozone problems can crop up anywhere.
Worldwide, East Asia, the Persian Gulf, India, northern South America, the Gulf of Guinea, and Malaysia/Indonesia have the highest ozone levels, although local conditions in other regions can also be poor.
Ozone can amplify the effects of other air pollutants, and vice versa.
“Breathing in other pollutants in the air may make your lungs more responsive to ozone, and breathing ozone may increase your body’s response to other pollutants. For example, research warns that breathing sulfur dioxide and nitrogen oxide can make the lungs react more strongly than just breathing ozone alone. Breathing ozone may also increase the response to allergens in people with allergies.” American Lung Association
For more information about the dangers of ambient ozone, go to the California Air Resources Board ozone information page.
Ozone isn’t just an urban problem. And it travels.
Ozone isn’t just an urban problem. And it travels. Ozone formation is more common in urban, industrial areas, but surprisingly, it can also be found at high levels in rural regions. Ozone along with its precursor pollutants (ready to form ozone) can be carried on the wind into rural areas, hundreds and possibly thousands of miles from the source. This can be equated to the long-distance paths taken by wildfire smoke plumes. In fact, wildfire smoke plumes carry ozone along with precursor VOCs and nitrogen oxides as they travel for thousands of miles.
Source: https://cires.colorado.edu/news/new-study-shows-how-wildfire-smoke-increases-ozone-pollution
On Ozone Alert days, one suggestions is to stay indoors. That can make sense when the air inside is better than the air outside. However, some research suggests that even with windows closed, ozone indoors can reach 25 to 50% percent of the outdoor level. If ozone is a problem outside, it can easily become one indoors, too. Ozone can be high indoors for two reasons: ozone infiltration and new indoor sources of ozone formation. Infiltration happens easily when doors or windows are left open, allowing ozone to get inside. Even with the windows closed, infiltration can happen if the building is “leaky,” you open the door frequently, or outside air is used for ventilation. Infiltration ozone can be hard to avoid as HVAC systems do not inherently reduce it. New ozone formation indoors occurs due to a range of products including ozone generating air purifiers, some water purification systems, photocopiers, and laser printers.
Ozone reacts with chemicals found in various products to produce other potentially toxic substances like formaldehyde, exacerbating its overall toxicity…Conversely, the presence of other air pollutants like particulate matter and sulfur dioxide can worsen the respiratory and cardiovascular impacts of ozone exposure. These pollutants likely inflame and damage the airways, making the lungs more vulnerable to ozone’s oxidative effects. Source: National Institutes of Health
There is a rapid solution to the IAQ problem
Ambient ozone can be removed indoors. Some technologies are better than others. Most air purification systems do not remove ozone at all. Among the methods that do remove ozone, there are wide differences in speed, effectiveness, and long-term value.
MERV and HEPA filter systems can only remove particles, and ozone is a gas.
Activated charcoal filters can trap ozone through adsorption, however, the removal pace is slow, and the charcoal is quickly expended in the process, requiring frequent, expensive filter changes.
PCO removes ozone, however the removal speed is very slow, due to the nature of the technology.
Catalytic degradation, used in Brio 650 is a more effective method for rapid ambient ozone removal.
FILTRATION TECHNOLOGY OZONE REMOVAL? Brio 650 with Refresh Plus Catalytic degradation Rapid removal, unlimited capacity MERV, HEPA Mechanical None Activated Charcoal Adsorption Slow removal, low capacity PCO Photocatalytic Oxidation Slow removalWrite to contact@agentisair.com or use the contact page.